Thermoworks P795 PRINTING DATALOGGER THERMOMETER Instrukcja Użytkownika Pobierz pdf (Strona 3)

1. Handling

1.1 General advice

- For cleaning the instrument please do not use abrasive cleaner but a dry or

wet piece of cloth.

- Please store the measuring instrument in a dry and clean place.

- Avoid any force like shocks or pressure to the instrument.

- Do not use force to connect the probe or interface plugs in. The interface

plug is different from the probe plug.

- If no sensor is connected to the instrument while switching on „open“ shows

on the display (Please refer to chapter error codes/troubleshooting).

- A retractable stand on the back of the instrument allows it to be used as a

bench top instrument.

1.2 Operation

Before switching on the instrument, connect the probe/s to the instrument and insert

the battery (Please refer to chapter 2. Power supply/changing the battery). A number

on the instrument’s housing marks each port.

1.3 Switching on and off

By operating the ON/OFF-key the instrument switched on or off. After switching on

the instrument indicates a full segment test for 15 seconds, then it starts to function

in measurement mode indicating the actual measurement value.

1.4 Menu

The adjustments of the instruments function: measurement value, calibration of

Probes, deactivation of channels, for example, are selected

from the menu structure. Enter into the main menu by

pushing [ENTER/MENUE]. Use the up and down keys []

to select the required menu. Push [ESC] to revert back to the

measuring mode.

Up and down keys

key [ESC]

key [ENTER/MENUE]

Menu structure

Unit Lin2 CAL Chnl Lo6

°C T1-T2 OFF OFF OFF

°F OP1 ON ON

Ohm OP2

OP3

OP4

1 2 3 4 5 6 7 8 9

Brak uwag

Thermoworks P795 PRINTING DATALOGGER THERMOMETER Instrukcja Użytkownika Strona 3