Thermoworks HAXO-8 LOGTAG TRANSIT RECORDERS User Manual Instrukcja Użytkownika Pobierz pdf (Strona 23)

Chapter 3 Quick Start Guide 21

In this screen you will see one of the following pictures next to each of the items in the

list:

 (no picture) indicates the LogTag is still in the process of being prepared for its next

use.



The LogTag was successfully prepared for its next use.



The LogTag failed to be prepared for next use. Press to try again.



The battery within the LogTag is low and is unlikely to have enough capacity to

record all the data you want during its next use. In this situation the LogTag should no

longer be used.

When all LogTags have finished receiving their new configuration data, click

to close the wizard. Your LogTag(s) are now ready to be started and used.

Please note that the automatic download feature is disabled in this screen. If you use the

button to configure a different LogTag, you may update the configuration of

a LogTag with unsaved data.

Starting and using the

LogTag

Once a LogTag has been successfully configured for use it is ready to be started. There

are two discrete methods available to start a LogTag recording, which are selected during

configuration. These start methods are explained in more detail in the chapter

Preparing LogTag for use

1 By pressing and holding the START MARK button on the LogTag until both the OK and

Alert lights alternately flash on and off.

2 By waiting until the date/time defined during configuration is reached, at which time

recording will automatically commence. Pressing the START MARK button will have no

effect until recording has commenced.

You can also have the LogTag record an "inspection" mark at any time while it is

recording, simply by pressing and holding the START MARK button on the LogTag until

both the OK and Alert lights flash on and off at the same time. You may have the LogTag

record as many inspection marks as you want while it is recording, however only one

inspection mark can be recorded per reading. In other words, if your LogTag is configured

to take readings at 15 minute intervals, inspection marks can be recorded at intervals of

15 minutes or more. If the LogTag has finished recording then pressing the START MARK

button will have no effect until after the LogTag has been prepared for next use.

Once the LogTag has started recording (either via Start button or date/time start) the

Alert and OK indicator lights operate in the following manner:

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 163 164

Brak uwag

Thermoworks HAXO-8 LOGTAG TRANSIT RECORDERS User Manual Instrukcja Użytkownika Strona 23